Guide rail

Angle.design’s guide rails fit all dive saws, and the rails are designed for you to use when cutting with a knife. You can extend the rails with any regular rails that you have – the principle behind them is the same. It can similarly be used together with screw clamps, etc.

You can rest assured that the rails will remain exactly where you want them as the foam tape on the back is very stable and very high friction. Use the rails on their own or together with the angle unit in order to cut all kinds of fibre gypsum board, woodcrete, MDF, steel plates and facade insulation.

If you require a high degree of accuracy, then it is a good idea to use a rail that is 30cm longer than the piece you are going to cut It is very important that your saw is sitting steady before you begin sawing through your piece.

Working range
The rails are primarily designed for cutting boards that are 30 cm / 12 inch shorter than the rails themselves.
You can easily combine the rails using the connecting piece and thereby increase your working length.